User manual

set forwarding
110 Chapter 2 Command Descriptions
Change an existing static route table entry
To change an existing static route table entry, these options are required:
staticrouteindex={1-8}
action=change
[one or more additional options]
Delete a static route table entry
To delete a static route entry, these options are required:
staticrouteindex={1-8}
action=delete
Enable a static route table entry
To enable a static route entry, all of its options must be specified (on this or
a previous command) and valid. That is, an entry can be enabled only if it is
completely valid.
When a new entry is added or a change is made to a static route entry and
that entry is enabled, the change is applied immediately to the IP routing
table. If a static route entry is disabled or deleted, it is removed immediately
from the IP routing table.
Display IP forwarding settings
show route
Display the current active IP routing table
display route
Options ipforwarding={on|off}
Enables or disables IP forwarding.
on
Enables IP forwarding.
off
Disables IP forwarding.
staticrouteindex={1-8}
Specifies which of the 8 static route table entries is to be acted upon.
action={add|change|delete}
Specifies the action to be performed on the selected static route table
entry.
add
Add a new entry.
change
Change one or more options of an existing entry.
delete
Delete an entry, resetting all its options to defaults (empty).