User manual

Access the Command Line
Chapter 1 Introduction 11
Access the Command Line
To configure devices using commands, you must first access the command
line, and then log on as needed.
This procedure assumes that you have already configured the Digi device
with an IP address.
1. To access the Command-Line Interface for the Digi device, enter the
following command from a command prompt on another networked
device, such as a server:
#> telnet ip address
where ip address is the Digi device’s IP address. For example:
#> telnet 192.3.23.5
2. If user authentication has been set up for the device, (that is, a user-
name and password have been set up for the device), a login prompt is
displayed. If you do not know the user name and password for the
device, contact the system administrator who configured the device.
The default username is “root” and the default password is “dbps.”
Configure an IP Address
If the device to which you will be issuing commands has not already been
assigned an IP address, or if the IP address needs to be modified from its
initial configuration, see the Digi product’s User’s Guide for details on
configuring an IP address.
Wireless devices "set wlan" on page 241.
"set ekahau" on page 104.
Feature/Task Commands