User manual

set ethernet
Chapter 2 Command Descriptions 107
set ethernet
Devices
supported
This command is supported in the following products:
• Connect Family: Digi Connect SP, Digi Connect EM, Connect ME.
• Digi Cellular Family: All Connect WAN products, but not
ConnectPort WAN VPN.
• ConnectPort Display.
Purpose Configures, adjusts, and displays Ethernet communications options.
Required
permissions
For Digi Connect products with two or more users, permissions must be set
to “set permissions s-ethernet=read” to display Ethernet communications
options, and “set permissions s-ethernet=rw” to display and configure
Ethernet communications options. See "set permissions" on page 157 for
details on setting user permissions for commands.
Syntax Configure Ethernet communications options
set ethernet [duplex={half|full|auto}] [speed={10|100|auto}]
Display Ethernet communications options
set ethernet
Options duplex
Determines the mode the Digi device uses to communicate on the
Ethernet network. Specify one of the following:
half
The device communicates in half-duplex mode.
full
The device communicates in full-duplex mode.
auto
The device senses the mode used on the network and adjusts
automatically.
The default is “half.” If one side of the Ethernet connection is using auto,
the other side can set the duplex value to whatever is desired. If one
side uses a fixed value (for example, half-duplex), the other side has to
use the same.