User manual

set dhcpserver
102 Chapter 2 Command Descriptions
Display current DHCP Server settings
#> set dhcpserver
DHCP Server Settings:
server enabled : on
scope name : eth0
starting ip address : 10.30.1.190
ending ip address : 10.30.1.198
lease time : 3600 (seconds)
offer delay : 500 (milliseconds)
addr conflict detect : off
Reservation Settings:
idx enabled ip address client id lease time
--- ------- --------------- ----------------- ----------
1 on 10.30.1.135 00:40:9D:24:73:F8 3600
2 on 10.30.1.195 00:09:26:19:51:05 0
3 on 10.30.1.196 00:09:26:19:51:06 0
4 on 10.30.1.197 00:09:26:19:51:07 0
5 on 0.0.0.0 00:00:00:00:00:00 0
6 on 0.0.0.0 00:00:00:00:00:00 0
7 off 0.0.0.0 00:00:00:00:00:00 0
8 off 0.0.0.0 00:00:00:00:00:00 0
9 off 0.0.0.0 00:00:00:00:00:00 0
10 off 0.0.0.0 00:00:00:00:00:00 0
11 off 0.0.0.0 00:00:00:00:00:00 0
12 off 0.0.0.0 00:00:00:00:00:00 0
13 off 0.0.0.0 00:00:00:00:00:00 0
14 off 0.0.0.0 00:00:00:00:00:00 0
15 off 0.0.0.0 00:00:00:00:00:00 0
16 off 0.0.0.0 00:00:00:00:00:00 0
A reservation lease time of 0 means to use the scope's lease time.
Exclusion Settings:
idx enabled start address end address
--- ------- --------------- ---------------
1 off 0.0.0.0 0.0.0.0
2 off 0.0.0.0 0.0.0.0
3 off 0.0.0.0 0.0.0.0
4 off 0.0.0.0 0.0.0.0