User`s guide

FastPort User’s Guide 3-3
7. Choose a name for the printer.
8. Choose the driver for the printer that is connected to the FastPort port.
The “Printer Setup” dialog box displays.
9. Change any of the desired printer-specific settings and choose OK.
Windows NT systems is now configured to print to FastPort.
3.1.4 Printing from Windows 95/98 or Windows NT 4.x (via SMB)
Note: This installation requires FastPort firmware 6.1 or higher.
1. Open Network Neighborhood.
2. Choose the workgroup where FastPort is located.
3. Double-click on FastPort. FastPort appears as FPXXXXXX; where
XXXXXX is the last six digits of the MAC address.
4. Double-click the port where the print job will go.
5. The “Do you want to create a printer on your local machine that prints
to this device” dialog box appears. Click Yes on this dialog box.
Figure 3-1. FastPort Menu Select
6. When prompted, select the driver for the printer connected to the
specific printer port.
7. Choose a local name to call this printer.
8. When prompted, choose to print a test page. A test page is printed out
on the FastPort-connected printer.
The Windows system is now configured to print to FastPort.