Specifications

Benhur Corporation – Multidyne, International Sales

Feature Benefits of the RGB-5000 UXGA Video, Audio, Data and Ethernet Fiber Link

• One Multimode or Singlemode fiber optic cable shall be used to connect a transmitter to a receiver.

• The transmitter and receiver pairs are self calibrating and adjusting to account for varying H and V scan rates and

resolution. Manual adjustments are not necessary and shall not be needed.

• An external computer is not required for system set-up and calibration.

• The system will lock instantly and automatically to changes in video format and resolution.

• The system is compatible with fiber optic switching.

• The system is available with optional fiber optic switching of all signals.

• The system will lock and support to all resolutions and scan rates as per RGB HV, RGsB, VGA, SVGA, UXGA with TTL

H & V sync, Sun and Apple Macintosh with TTL, composite sync, Silicon Graphics with sync on-green standards and

specificatioopns.

• No front panel controls are offered limiting installation setup, calibration and prevents systems tampering.

• The system uses 24 bit encoding with 8 bits for each of the Red, Green and Blue video signal components.

• A reduction from 24 bit encoding at higher scan rates is not performed preventing banding or contouring distortions.

• All units are available in either stand-alone or rack mounted configurations

• All units are powered by 5VDC in either configuration

• Power consumption is to be limited to 15 Watts

• Up to three transmitter or receiver units fit in one 19 inch rack-unit.

• Transmitters shall have a looping HD-15 connector for local monitoring

• The operational temperature range shall be 0C to +70C

• Video resolution of 1600 x 1200 @ 75 HZ shall be supported

• Horizontal scan rates of 15.75 to 130 kHz and vertical scan rates of 50 to 150 Hz shall be supported

• Location and detection of sync signals shall be automatic

• Data throughput of 3.125 Gbps with no compression shall be supported

• Video and sync jitter shall be <5 nano seconds

• Video signal to noise ratio shall be >60db

• Optional stereo line level audio channel in the same direction as the video is supported

• Audio connector is 3.5mm stereo plug on the transmitter and the receiver

• Optional Bi-directional RS-232 or RS-422 data is supported. The data format is field selectable be either jumper or

switch selection.

• Optional 10 Base T Ehternet is supported

• Optional Daisy-chain or drop and repeat feature is available on the receiver units.

• Optionally transport up to 18 UXGA video signals over ONE fiber using CWDM optical multiplxing

RGB-5000

Fiber Transport: RGB, VGA, DVI, HDMI, KVM