Specifications

Digi m10 Hardware Reference v 1.20

Page 8 of 38

Industry Canada Notice

This equipment has been tested and found to be in compliance with the limits for Industry Canada

requirements.

Operation is subject to the following two conditions: 1) this device may not cause harmful

interference, and 2) this device must accept any interference received, including interference that

may cause undesired operation.

Caution

To comply with the IC radio frequency exposure requirements, the following antenna installation

and device operating configurations must be satisfied:

# Product models using external antennas require professional installation. The antennas used

for professional installation must be fixed-mounted on indoor/outdoor permanent structures with a

separation distance from all persons more than 50 cm (approximately 20 inches).

# Antennas must not be co-located and must not operate in conjunction with any other antenna or

transmitter.

In the event of a problem, please contact the after sales service network.

As per Directive 2002/96/EC of the European Parliament and Council on waste

and electrical equipment (WEEE), the product should be returned to the

distributor after the end of product life.

Where to Get Help

For additional information or clarifications regarding this user manual, please get in touch with

Digi International using the contact information provided below.

Address

11001 Bren Road East

Minnetonka, MN 55343

Phone

952-912-3456

http://www.digi.com/support/eservice/login.jsp