Installation guide

S6 Installation Guide66
Attaching the Upper Rear Panels
After installing and connecting all modules, attach the upper Rear Panels.
To install the upper Rear Panels:
1 Take one of the upper Rear Panels and lower it into place so that its mounting screw lines up with the receiver on the lower panel,
then secure its thumb-screw into the threaded receiver on the Rear Panel Mounting Bracket.
2 Do the following before closing the panels as appropriate for your system:
• If your system includes Display Modules, make sure their power and Ethernet cables are guided through the cutouts at the cor-
ners of the upper Rear Panel, then close the cover to conceal cables. Do not install the Display Module Fillers.
• If your system does not include Display Modules, close the Rear Panel upper covers and then install Display Module Fillers
(shown in Figure 42) to seal the openings at the corners of adjacent covers. One Filler is included with each chassis.
Figure 40. Upper Rear Panel
Figure 41. Attaching the Upper Rear Panel (Display Module cables not shown)
Make sure the Display Module cables are not pinched when the upper Rear Panel is closed to avoid damaging the cables.
Figure 42. Display Module Filler