Installation guide

S6 Installation Guide64

Complete the Hardware Assembly

After confirming power and Ethernet connections, add Compression Panels and T-Strips to secure the modules in place, and install

upper Rear Panels to conceal cables.

Installing Compression Panels

After you have installed all modules and covered any empty slots with Fill Panels, install a Compression Panel at the top of each

chassis.

Compression Panels are spring-loaded panels that seal the top of each chassis and hold the modules in place. Compression Panels

come in three sizes, Channel (included with all frame chassis kits), Master ED (for the master chassis in systems comprised of

Frame Chassis Large), and Master RD (for the master section chassis in systems comprised of Frame Chassis Small).

To install Compression Panels:

1 Unpack the Compression Panels (included in the Rear Panels package). Remove the protective film from each panel.

2 If there is a Display Module mounted for that chassis, make sure the power and Ethernet cables are routed through the opening

in the Back Tie Plate (these will be held in place later when you attach the upper Rear Panels).

3 Holding the panel at an angle, place the spring side of the panel against the back of the chassis and apply enough pressure to com-

press the springs, then lower the front edge of the Compression Panel into place at the top of the chassis as shown in Figure 37.

4 Repeat for other Channel chassis.

Figure 36. Compression Panels: Channel (left) and two Master sizes; Large (center), and Small (right)

Figure 37. Installing a Channel Compression Panel