Installation guide

S6 Installation Guide58
Installing the Master Module
Installing a Master Module is similar to other modules but requires additional connections.
To install the Master Modules:
1 Hold the Master Module above the chassis and connect two of the 2-pin Molex cables in the Cable Harness, one to each of the
two DC inputs on the side of the module as shown in Figure 33.
2 Connect the longest available Ethernet cable to the Ethernet port on the side of the module (see Figure 34):
Figure 33. Connecting both DC power cables to the Master Module
Figure 34. Master Module side panel Ethernet port
Gigabit Ethernet RJ45