Installation guide

S6 Installation Guide50
Attaching the Outer Side Covers
After cables are in place, install the outer side covers (outer side covers must be installed before modules).
To attach the Side Covers:
1 Before attaching the outer Side Covers, make sure to route the single Ethernet (workstation) cable and the AC supply to the
power strip across the Rear Panels and down through the gap to the right (or left) of the outer Rear Panels (see Figure 27).
2 Make sure power and Ethernet cables are not in the way, then set the panel into the side bracket so that its tabs hang on the slots
on the mounting plate as shown in Figure 28.
Figure 27. Gap for power strip AC and workstation Ethernet
Figure 28. Attaching the left Side Cover