Installation guide

S6 Installation Guide36
Installing the Power Strip
The power strip is placed across the Rear Panel brackets, behind the center of the frame.
To install the power strip:
1 Standing behind the middle of the frame, place the power strip on the Rear Panel brackets so that it sits on the angled arms of
the brackets as shown in Figure 2. The power strip’s sockets should face up and towards the front of the frame.
.
2 Take the power strip’s AC cable and run it along the back of the frame to the far left or right end. Do not connect to power outlet
yet.
Figure 2. Power strip placement on Rear Panel brackets (back view at left, side view at right)
(Not to scale)