Installation guide
Chapter 4: Assembling Frame Chassis 31
Installing Side Covers
Side Covers (one Left, and one Right) consist of two pieces: a mounting plate that attaches to the frame, and an outer panel that at-
taches to the mounting plate and secured from inside the chassis.
Attaching the Side Mounting Plates
To attach the Side Mounting Plates:
1 Unpack the Side Covers package and identify the Left and Right Side Mounting Plates and their fasteners.
2 Secure the Left Side Mounting Plate to the left side of the frame using the included (rounded) Phillips screws, making sure to
orient the brackets correctly as shown in Figure 30.
3 Secure the Right Side Mounting Plate to the right side of the frame, making sure to orient them correctly as shown in Figure 31.
4 Set the outer Side Covers aside for now. You will install them later, after cabling is in place.
Fasteners and Tools for the Side Mounting Plate
Fasteners
M4x14 SEMS (7760-30610-00)
Tool
#2 Phillips
Figure 30. Attaching the left side panel mounting plates
Figure 31. Attaching the right side panel mounting plates
(Not to scale)