Installation guide

Chapter 4: Assembling Frame Chassis 29
Installing Display Module Mounting Brackets
If your system includes Display Modules, install their mounting brackets as explained in the following instructions. (The Display
Modules are attached to the mounting brackets later.)
If your system does not include Display Modules, proceed to “Installing Rear Panel Mounting Brackets” on page 30.
If your system includes one or more Display Modules, do the following:
1 Unpack all S6 Display Modules and locate their mounting brackets. Fasteners are included in a small bag taped to the bracket.
Use the four flathead Hex fasteners to attach the brackets to the chassis. Set the other four rounded fasteners aside (these will be
used to attach the module to the brackets later).
2 Attach the first Display Module Mounting Bracket to the four holes located on the center of each channel chassis’ Back Tie Plate
using four flathead Hex fasteners. Be sure to orient the brackets correctly, as shown in Figure 26. Do not attach a Display Module
Mounting Bracket to the chassis that will contain your master section modules.
3 Repeat for other Display Modules, attaching their brackets to the back of each channel chassis.
4 Leave the actual Display Modules aside for now. You will attach them to the mounting brackets later.
Fasteners and Tools for the Display Module Mounting Brackets
Fasteners
M5x12 FHCS
Tool
M3 Hex
Figure 26. Attaching Display Module Mounting Brackets
(Not to scale)