Installation guide

S6 Installation Guide26
Attaching the Back Feet
To attach the Back Feet:
1 Unpack each Back Foot and screws from each Frame Chassis kit. Locate and unpack the additional Back Foot in the Side Covers
package.
2 Using a #2 Phillips screwdriver (magnetic tip recommended) and included #2 Phillips screws, attach the assembled feet to the
back of the frame. Be sure to orient them correctly before securing them to the frame.
• At the left- and right-most ends of the frame, attach the feet to the Spacer bars and adjacent Back Tie Plates as shown in
Figure 22.
Back Feet
Back Feet and
Fasteners
7020-38616-00
Back Foot, Mounting Bracket, and screws
The number of back feet is equal to the number of chassis (width) of the frame, plus one. For example, a 16-fader S6 system has
a frame width of three chassis, so it requires four back feet (3+1=4). Similarly, a 32-fader system requires six back feet (5+1=6).
Fasteners and Tools for Back Foot Mounting Bracket to chassis
Fasteners
M5x12 (7760-30554-00)
Figure 22. Attaching a Back Foot at one end of the back of the frame
If the threaded foot blocks access to the mounting screws extend the foot a few turns. See “Leveling the Chassis” on page 27.
(Not to scale)