Installation guide

Chapter 4: Assembling Frame Chassis 25
Attaching the Back Feet
After assembling the chassis, attach the back feet.
• One Back Foot is included with each Frame Chassis Kit.
• Two Back Foot Mounting Spacer bars and an additional Back Foot are included in the Side Covers kit.
Installing Back Foot Mounting Spacers
To install the two Back Foot Mounting Spacers:
1 Locate the Back Foot Mounting Spacer bars (2) included in the Side Covers kit.
2 Standing at the back of the frame, attach one Spacer bar to the left and right back corners of the frame using two Hex fasteners
per bar as shown in Figure 21. Make sure to orient the Spacers correctly.
Back Foot Mounting Spacer Bars included in the Side Covers kit
Back Foot Spacers
7600-31390-00
Fasteners and Tools for Book Foot Mounting Spacer Bars to Side Walls
Fasteners
M5x8 FHCS (7760-30553-00)
Tool
M3 Hex
Figure 21. Back Foot Mounting Spacer Bars (upper left), and attaching the Back Foot Mounting Spacer bars
(Not to scale)