Installation guide

Chapter 4: Assembling Frame Chassis 21
Assembling the Chassis
If you have not already done so, unpack all Frame Chassis and fasteners and arrange them next to each other on your work surface.
The Chassis kits also include tie-down brackets (for PSUs), a T-Strip, and Display Module Fillers. Set these aside for now.
Attaching the End Side Wall
To attach the end Side Wall:
1 Open the S6 Side Covers package and unpack the included Side Wall.
2 Attach the Side Wall to the Chassis Bottom Plate of the right-most chassis using three #1 Phillips screws. The right edge of the
Chassis Bottom Plate sits on top of the left edge of the Side Wall as shown in Figure 14.
Figure 12. Four Frame Chassis Small
Figure 13. End Side Wall
Fasteners, and Tools for Chassis Bottom Plate to Side Wall
Fasteners
M3x6 SEMS (7760-30025-01)
Tool
#1 Phillips
Figure 14. Securing the end Side Wall to the Chassis Bottom Plate, top view (at left) and front view (lower right)
(Not to scale)