Installation guide

Chapter 3: Assembling Legs 15
Attaching the Front Beam
To attach the front Beam:
1 Align the pins on the underside of the Beam with the holes in the top of the Legs. Be sure to orient the front Beam so that the
pins on the top are closer to the center of the frame.
2 Using four fasteners and washers (included) per mount, attach the Beam across the front of the Legs using two Beam Mounting
Plates as shown in Figure 4. Do not tighten the fasteners.
Fasteners, Washers, and Tools for Legs to Beams
Fastener
M8x40
Washer
M8
Tool
M6 Hex
Figure 4. Orientation of the pins on the top of the front beam
(Not to scale)