Installation guide

S6 Installation Guide14

Attaching the Back Beam

Attaching the back Beam:

1 Place one of the Beams on the floor to determine how far apart the Legs need to be.

2 Attach the back beam by doing the following (see Figure 2):

• Put the first Beam across the back of the Legs. Align the pins on the underside of the Beams with the holes in the top of the

Legs. Be sure to orient the back Beam so that the pins on the top are closer to the center of the frame.

• Using four fasteners and washers (included) per mount, secure the Beam with Mounting Plates at each end. Do not tighten

down fasteners all the way until both beams and both Back Corner Brackets are in place.

3 Make sure the Beam sits flat on the top of the legs as shown in Figure 3. If necessary, move the legs in or out until the proper

alignment is achieved.

Have someone help hold the components while you position the Beams on the Legs and attach the fasteners.

Fasteners, Washers, and Tools for Legs to Beams

Fastener

M8x40

Washer

Tool

M6 Hex

Figure 2. Attaching a Beam to the Legs using a Beam Mounting Plate

Figure 3. Back view showing correct alignment of Beam on leg (at left), and incorrect alignment (middle, and right)

(Not to scale)