Installation guide

Chapter 3: Assembling Legs 13

Chapter 3: Assembling Legs

This chapter explains how to assemble the Leg Frames for the S6. Not all systems require Legs. If your system does not include

Leg Frames, please proceed to Chapter 4, “Assembling Frame Chassis.”

Unpack the Leg Frames

Unpack the Legs and Beams and identify the components shown in Figure 1.

1 – Legs

2 – Beams

3 – Beam Mounting Plates

4 – Back Corner Brackets

5 – End Shelves

6 – Fasteners and Tools (not shown)

Overview of Leg Frame Assembly

The Leg Frames consist of two Beams mounted across the back and front of the Legs and secured with Corner Brackets, Left and

Right End Shelves, and leveling feet.

When assembling a Leg Frame as described in the next section, you should start by placing one of the Beams on the floor to gauge

how far apart the Legs need to be. Place the Legs parallel on the floor with proper spacing and put the first Beam across the back

of the Legs, orienting it as shown in the following diagrams and securing it with the Beam Mounting Plates and fasteners. Do not

tighten down fasteners all the way until both Beams and both Back Corner Brackets are in place. Once the back Beam is secured

then place the other Beam across the front and secure it with Beam Mounting Plates and fasteners.

Make sure you have at least one other person available if you need to lift, turn, or move the system during and after assembly. Com-

ponents and systems are heavy! Team lift, always.

Figure 1. Legs Frame components