User`s guide

97
5. In the Peer Configuration section, select an option for assigning the IP address of
incoming PPP client.
Automatically assign remote IP address from IP address pool: If you select this option,
IP address for incoming PPP client will be automatically assigned from the IP address pool
set on Basic PPP Settings page
Allow remote peer to specify remote IP address: If you select this option, incoming PPP
client will specify the IP address used for this PPP connection.
Assign static remote IP address: If you select this option, IP address for incoming PPP
client will be assigned as specified at Remote IP address
6. In the Peer Configuration section, check Allow client access to local network via PPP
connection if you want the incoming PPP client to be able to access the ConnectPort LTS,
or other devices on the network through the PPP interface of ConnectPort LTS. Once you
enable this option, you can select another option for assigning the IP address of local PPP
interface.
Automatically assign local IP address from IP address pool: The IP address for the local
PPP interface is automatically assigned from the IP address pool set on Basic PPP Settings
page.
Assign static local IP address: The IP address for local PPP interface is assigned as
specified at Local IP address.
7. In the Advanced Configuration section, check Enable idle timeout if you want to close
PPP connection when there is no activity from the incoming PPP client during the time
specified at Timeout (sec).
 Advanced PPP Settings:
If you want to the incoming PPP client to be able to access the local network where the
ConnectPort LTS is connected, check the Process ARP Requests (Proxy ARP) option.