User`s guide

87
Modem
ConnectPort LTS W has an internal modem that is configured it on this page. The Modem
configuration page has the same configuration settings of Modem Profile of Serial port settings and
it allows you to establish or receive connections from other systems and internal modems. Modem
configuration page allow you to use the following type of connection
 Incoming Connection: Used for dial-in connections, such as inbound PPP connections or to
manage a device through a telephone network. The ConnectPort LTS product server will
receive connections from other hosts.
 Outgoing Connection: The modem will dial-out to establish connections with external hosts or
to connect to an external PPP network.
 Network Bridge Connection (bi-directional): The modem can be used both to establish
connections to other hosts as well as receive connections from other hosts.
The Modem configuration page also allows you to configure the following settings:
 Init String: This is the modem initialization settings. Modify the init string to change the
behavior of the modem as needed by your application.
Note: if the modem is currently in use, the init string change will not take effect immediately. It
will be used the next time the modem is initialized.
 Enable PPP Connections on this Modem: If enabled, the modem will be used for PPP
connections. You will need to configure the PPP connection through PPP configuration.
 Enable callback: If the callback is enabled, the ConnectPort LTS product disconnects the
connection from a remote site and then calls the phone number specified at the callback phone
number.
 Callback phone number: The phone number which the ConnectPort LTS product calls with
callback enabled.
 Dial-in modem callback login: The ConnectPort LTS product calls the phone number
specified at the callback phone number after a user authentication.
 Allow dial-in modem callback number change: The ConnectPort LTS product will ask a user
whether to change the callback phone number before calling.