User`s guide

83
Add users
Digi Connect Family products allow multiple users to be defined. For those products, the Users
Configuration page shows the currently defined users and allows you to add more user definitions.
To add a user definition:
1. On the Main menu, click Users.
2. On the Users Configuration page, click New.
3. On the Add New Users page, specify the user name and password to be used for login. The
password can be from 4 through 16 characters long and is case-sensitive. Confirm the password,
and click Apply. The changes take effect immediately. No logout/login is necessary.
User access settings
For ConnectPort LTS products with the two-user or more-than-two-users model, user access to the
device interfaces is configurable. For example, the administrative user can access both the
command line and web interface, but other users can be restricted to the web interface only.
Take care in changing access settings. If you are logged in as the administrative user and disable
web interface, you will not be able to log in to the ConnectPort LTS product on your next attempt,
and there is no way to raise your user permissions to enable the web interface again. You must reset
the device to factory defaults to enable the web interface access.
To set access settings:
1. On the Main menu, click Users.
2. On the Users Configuration page list of users, click on the user.
3. On the User Access page, enable or disable the device interface access as desired:
– System Interface Access
Shell: Enables or disables access to the shell program of command line interface.
CLI menu: Enables or disables access to the menu program of command line interface.
– Web Interface Access
Allow web interface access: Enables or disables access to the web interface.
4. Click Apply. The changes take effect immediately. No logout/login is necessary.