User`s guide

69
TCP settings
The TCP Settings are displayed only when the current serial port is configured with the TCP
Sockets or the Custom Profile. The settings are as follows:
 Send Socket ID: Include an optional identifier string with the data sent over the
network. The Socket ID can be 1 to 256 ASCII characters. To enter non-printable characters,
use these key sequences:
Character Key Sequence
backspace \b
formfeed \f
tab \t
new line \n
return \r
backlash \\
hexadecimal values \xhh
 Send data only under any of the following conditions: Enable if it is required to set
conditions on whether the ConnectPort LTS product sends the data read from the serial port to
the TCP destination. Conditions include:
− Send when data is present on the serial line: Send the data to the network destinations
when a specific string of characters is detected in the serial data. Enter the string 1 to 4
characters in the Match String field. To enter non-printable characters, use these key
sequences:
Character Key Sequence
hexadecimal values \xhh
tab \t
linefeed \n
backspace \b
− Strip match string before sending: Match string before sending to strip the string from
the data before it is sent to the destination.