User`s guide

59
Socket tunnel settings
A Socket Tunnel can be used to connect two network devices: one on the ConnectPort LTS
product’s local network and the other on the remote network. This is especially useful for providing
SSL data protection when the local devices do not support the SSL protocol. One of the endpoint
devices is configured to initiate the socket tunnel. The tunnel is initiated when that device opens a
TCP socket to the ConnectPort LTS product on the configured port number. The ConnectPort LTS
product then opens a separate connection to the specified destination host. Once the tunnel is
established, the ConnectPort LTS product acts as a proxy for the data between the remote network
socket and the local network socket, regardless of which end initiated the tunnel.
Socket Tunnel settings include:
 Enable: Enables or disables the configured socket tunnel.
 Timeout: The timeout (specified in seconds) controls how long the tunnel will remain
connected when there is no tunnel traffic. If the timeout value is zero, then no timeout is in
effect and the tunnel will stay up until some other event causes it to close.
 Initiating Host: The hostname or IP address of the network device which will initiate
the tunnel. This field is optional.
 Initiating Port: Specify the port number that the ConnectPort LTS product will use to
listen for the initial tunnel connection.
 Initiating Protocol: The protocol used between the device that initiates the tunnel and
the ConnectPort LTS product. Currently, TCP and SSL are the two supported protocols.
 Destination Host: The hostname or IP address of the destination network device.
 Destination Port: Specify the port number that the ConnectPort LTS product will use
to make a connection to the destination device.
 Destination Protocol: This is the protocol used between ConnectPort LTS product and
the destination device. Currently, TCP and SSL are the two supported protocols. This protocol
does not need to be the same for both connections.