User`s guide

128
Using the Reset button
If the ConnectPort LTS device cannot be accessed from the web interface, the configuration can be
restored to factory defaults by using the Reset button. In this case, all current settings including the
IP settings will be cleared.
Reset ConnectPort LTS
1. Locate the Factory Reset button on the front of device, as shown in the figure. Use a non-
conducive, small diameter tool (such as wood or plastic) with a blunt end (NOT SHARP or the
button could be damaged) to press gently.
2. Hold down the reset button about 2~3 seconds and then release it.
3. Check the status of Ready LED. When the restoration is complete, Ready LED will be turn on
again.