User`s guide

118
info
The info command displays statistical information about a device over time. The statistics displayed
are those gathered since the tables containing the statistics were last cleared. Info keywords display
the following types of statistics:
 Device statistics. info device displays such details as product, MAC address, bios, and firmware
versions, memory usage, utilization, and uptime. For models with dual power supplies, such as
ConnectPort LTS 16 MEI 2AC, this command displays the status of the power supplies.
 Ethernet statistics. info ethernet displays statistics regarding the Ethernet interface, including
the number of bytes and packets sent and received, the number of incoming and outgoing bytes
that were discarded or that contained errors, the number of Rx overruns, the number of times
the transmitter has been reset, and the number of incoming bytes when the protocol was
unknown.
 ICMP statistics. info icmp displays the number of messages, bad messages, and destination
unreachable messages received.
 Serial statistics. info serial displays the number of bytes received and transmitted, signal
changes, FIFO and buffer overruns, framing and parity errors, and breaks detected.
 TCP statistics. info tcp displays the number of segments received or sent, the number of active
and passive opens, the number of bad segments received, the number of failed connection
attempts, the number of segments retransmitted, and the number of established connections that
have been reset.
 UDP statistics. info udp displays the number of datagrams received or sent, bad datagrams
received, and the number of received datagrams that were discarded because the specified port
was invalid.
 ZigBee statistics. info zigbee_sockets displays the number of frames received or sent, bad
frames received or sent, the number of bytes received or sent and the number of received bytes
dropped or truncated.