Installation guide

99
Options add
Add a port group. A maximum of 16 port groups can be defined.
remove
Remove port groups
index=1-16
Specifies the index number of port group or range of port group indexes to
be acted on.
name=group name
Specifies the name of port group to be acted on.
ports=0-32
Serial port or range of serial ports. If “port=0” is specified, all ports
specified to this port group will be reset.
showdata={on|off}
When enabled, user can see the data from other ports in the same group
from a terminal connected to the one of serial ports in the group.
on
Enable showing data from other ports in the same group.
off
Disable showing data from other ports in the same group.
Default is off.
sendbyte=1-4096
Sends data to the other ports in the same group after the specified number of
bytes has been received on the serial port. This can be 1 to 4096 bytes.
Default is 1024 bytes.
sendidle=1-65535
Sends data to the other ports in the same group after the specified idle time
has been passed with no additional data received on the serial port. Range is
1 to 65,535 milliseconds. Default is 1000 milliseconds.
newname =new group name
Name of port group when new port group is created.
Example #> set portgroup add index=1 ports=1,2,4-5
newname=testgroup
See also • "show "