Installation guide

7
Quick reference for configuring features
The following table shows common features that can be configured from the command line, and the
commands used to configure each feature. If you are viewing the PDF file of this document, click the
commands in the “Commands” column to go to the command descriptions.
Feature/Task
Commands
Alarms
"set alarm".
Autoconnection (automatically connect a user
to a server or network device)
"set autoconnect".
"set serial".
"set tcpserial".
Configuration management/administration
Backup/restore a configuration from a TFTP server on the
network: "backup"
Update firmware: "boot"
Reset configuration to factory defaults: "revert" or
“boot action=factory” (see "boot")
Reboot the device: "boot"
Display current configuration settings in a
device
"show"
Ethernet settings
"set ethernet"
Help on device commands
"help and ?"
Host name for a device (Specify a name for
the device)
"set host"
IP address settings
"set network"
Multiple Electrical Interface (MEI)
"set switches"
Point to Point Protocol (PPP)
"set ppp"
Port buffering
"display buffers"
"set buffer"
Port profiles: sets of preconfigured serial-port
settings for a particular use
"set profile"