Installation guide

64
set ethernet
Purpose Configures, adjusts, and displays Ethernet communications options.
Required permissions For products with two or more users, permissions must be set to “set
permissions s-ethernet=read” to display Ethernet communications options, and
“set permissions s-ethernet=rw” to display and configure Ethernet
communications options. See "set permissions" for details on setting user
permissions for commands.
Syntax Configure Ethernet communications options
set ethernet [index=1-2]
[duplex={half|full|auto}]
[speed={10|100|1000|auto}]
Display Ethernet communications options
set ethernet
Options index=1-2
Used to specify the index of the Ethernet device
duplex
Determines the mode the ConnectPort LTS product uses to communicate
on the Ethernet network. Specify one of the following:
half
The device communicates in half-duplex mode.
full
The device communicates in full-duplex mode.
auto
The device senses the mode used on the network and adjusts
automatically.
The default is “auto.” If one side of the Ethernet connection uses auto, the
other side can set the duplex value to whatever is desired. If one side uses a
fixed value (for example, half-duplex), the other side has to use the same.
If the “speed” value is set to auto, auto is only allowed for the duplex value.