Installation guide

6
1. Introduction
This book describes the commands in the command-line interface for several Digi product families, listed
below. This chapter provides the following:
A quick reference showing the commands used to configure features or perform configuration tasks
from the command line.
Basic information that applies to all commands, including navigation and editing keys, displaying
online help, abbreviating commands, syntax conventions, and entering special characters in string
values.
How to access the command line.
How to configure an IP address for a ConnectPort LTS product from the command line, if an address
has not already been assigned.
Information about user models and user permissions in ConnectPort LTS products, and how they
affect the commands you can issue.
Products to which this book applies
This manual documents the command-line interface for the ConnectPort LTS Family, which includes
these products:
ConnectPort LTS 8
ConnectPort LTS 8 MEI
ConnectPort LTS 8 W
ConnectPort LTS 8 MEI W
ConnectPort LTS 16
ConnectPort LTS 16 MEI
ConnectPort LTS 16 W
ConnectPort LTS 16 MEI W
ConnectPort LTS 16 MEI 2AC
ConnectPort LTS 32
ConnectPort LTS 32 MEI
ConnectPort LTS 32 W
ConnectPort LTS 32 MEI W