Installation guide

56
Syntax Configure autoconnect
set autoconnect
[port={range|xbee|internalmodem}]
[state={on|off}]
[trigger={always|data|dcd|dsr|string}]
[service={raw|rlogin|ssl|telnet|ssh}]
[description=string]
[ipaddress=ip address]
[ipport=ip port]
[connect on string=string]
[flush_string={on|off}]
[keepalive={on|off}]
[nodelay=on|off]
Display autoconnect settings
set autoconnect [port={range|xbee|internalmodem}]
Options port={range|xbee|internalmodem}
Used to specify the serial port. Optional on a single-port device.
To configure settings for the XBee port, specify “port=xbee.”And to
configure settings for an internal modem port, specify
“port=internalmodem.”
state={on|off}
Enables or disables the autoconnect feature.
on
Enables the autoconnect feature.
off
Disables the autoconnect feature.
The default is off.
If you are using the serial port for another purpose, it is recommended this
value be set to “off.”