Installation guide

55
set autoconnect
Purpose Used to establish an automatic connection (autoconnection) between the serial
port and a remote network destination, and to display current autoconnect
settings.
Required permissions For products with two or more users, to use this command, permissions must
be set to one of the following:
For a user to display autoconnect settings for the line on which they are
logged in: “set permissions s-autoconnect=r-self”
For a user to display autoconnect settings for any line:
“set permissions s-autoconnect=read”
For a user to display and set the autoconnect settings for the line on which
they are logged in: “set permissions s-autoconnect=rw-self”
For a user to display autoconnect settings for any line, and set the
autoconnect settings for the line on which the user is logged in: “set
permissions s-autoconnect=w-self-r”
For a user to display and set the autoconnect settings on any line: “set
permissions s-autoconnect=rw” See "set permissions" for details on setting
user permissions for commands.