Installation guide

44
reconnect
Purpose Reestablishes a previously established connection; that is, a connection opened
by a “connect,” “rlogin,” or “telnet” command. The default operation of this
command is to reconnect to the last active session.
Required permissions For products with two or more users, permissions must be set to “set
permissions reconnect=execute” to use this command. See "set permissions"
for details on setting user permissions for commands.
Syntax reconnect [{serial port|
p=serial port|s=session}]
Options serial port
The serial port to which this command applies. Use this option to reconnect
to a session opened by a connect command.
p=serial port | s=session
The serial port number or session number (displayed by the “status”
command) to reconnect to. In case of serial port, the session order to
reconnect is current active session and then small session id if there are two
or more sessions for a serial port and user specify “p=serial port” option to
reconnect.
Examples Reconnect to the last port used
#> reconnect
Reconnect to port 1
#> reconnect p=1
Reconnect to session 1
#> reconnect s=1
See also • "connect" for information on establishing a connection on a selected port.
• "close" for information on ending a connection.
• "status" for information on gathering status on current
connections.
• "rlogin"
• "telnet"