Installation guide

172
set user
Purpose Used to:
Add users for access to a ConnectPort LTS product. Up to 32 users
can be defined.
Associate a user with up to two groups. A user can be associated
with up to two groups.
Disassociate a user from a group.
Remove users.
Change user settings.
Display user settings.
Load an SSH public key.
Required permissions For products with two or more users, to use this command, permissions must
be set to one of the following:
For a user to display user configuration attributes:
“set permissions s-user=read”
For a user to display and set user configuration attributes:
“set permissions s-user=rw”
See "set permissions" for details on setting user permissions for commands.
Default permissions for a new user
When a new user is created, it is given a set of default permissions. Once a
user is created, an administrator can adjust permissions up or down as needed.
Default permissions for a new user are as follows. For more information on
user permissions, see "set permissions."
none: backup, boot, buffers, connect, display, filesys, kill, revert-all,
s-alarm, s-pmodem, s-snmp, status, s-trace, s-profile, ping, python,
s-internalmodem,s-lcd, s-modem, s-ppp, s-portauth,
s-python, s-serial, s-sdmemory, s-sysauth, s-socket_tunnel, s-term,
s-usb, s-xbee, webui
execute: reconnect, rlogin, telnet, who
read: s-host, s-permissions, s-ethernet, s-group, s-network, s-serial,
s-service, s-system, s-user
r-self: s-autoconnect, s-rtstoggle, s-tcpserial, s-udpserial
rw-self: newpass