Installation guide

17
boot
Purpose Reboots the ConnectPort LTS product, restores the device configuration to
factory default settings, or loads new firmware files from a TFTP server.
Required permissions For products with two or more users, permissions must be set to “set
permissions boot=execute” to use this command. See "set permissions" for
details on setting user permissions for commands.
Syntax Reboot the ConnectPort LTS product
boot action=reset
Restore configuration defaults
boot action=factory
Load new firmware into flash ROM from a TFTP host
boot load=host ip address:loadfile
Options action
The action to be performed.
factory
Resets the entire configuration to factory defaults, and then reboots
the device.
reset
Reboots the device.
load
The firmware to be loaded.
host ip address
The IP address of a host with new firmware, which is then burned
into flash ROM. The host must be running a TFTP server.
loadfile
The name of a firmware file. The software automatically detects the
type of file and performs the appropriate load operation.