Installation guide

165
Syntax Set general UDP serial forwarding characteristics for a serial port
set udpserial port={range|xbee|internalmodem}
[state={on|off}]
[sendcount=bytes]
[sendtime={0|time}]
[endpattern=string]
[strippattern={on|off}]
[sid={on|off}]
[sidstring=string}
Set UDP destinations for a given serial port
set udpserial port=range
range=1-64
[active={on|off}
[ipaddress=ip address}
[ipport=ip port]
Display current UDP serial settings
set udpserial [port=range [range=range]]
Options Options for setting general UDP serial forwarding characteristics
port=range
Used to specify the serial port. Optional on a single-port device.
To configure settings for an XBee port, specify “port=xbee”. To
configure settings for an internal modem port, specify
“port=internalmodem”.
state={on|off}
Indicates whether an established network connection should be
terminated when the serial port’s DCD signal drops. The default is
“off.”
sendcount=bytes
The number of bytes received from the serial port that will cause the
data to be sent on to the network destinations. This trigger cannot be
disabled. The default is 1024 bytes.