Installation guide

162
mask=type:severity
Identifies the type and nature of events that should be traced, and the
severity level of the events.
type
The type of events that should be traced. Enter “set
trace ?“ to view the list of types supported in the
ConnectPort LTS product. Some commonly used trace types
for diagnosing connection problems are “modem” and “ppp.”
Contact Digi Technical Support for assistance in using the
appropriate type keyword.
severity={assert|critical|warning|info|debug}
The severity level of events traced.
assert
Tracing is done on assert lines only. This severity
level is for Digi-internal use only.
critical
Tracing is done on only the most severe events.
This is the default severity level. This level
produces the least amount of trace data.
warning
Tracing is done on critical events and on less
severe events as well. This level produces more
trace data than “critical,” but less than “info.”
info
Tracing is done on many events. It produces more
trace data than assert, critical, and warning levels.
debug
This severity level is used for Digi-internal
debugging purposes only.