Installation guide

160
set trace
Purpose Configures a ConnectPort LTS product for tracing and displays tracing
information.
Important: The “set trace” command should be used when working
with Digi Technical Support. Enabling tracing can have an impact on
system performance. Digi provides no guarantee that trace output is
the same across firmware revisions.
Required permissions For Digi products with two or more users, permissions must be set to
“set permissions s-trace=read” to display tracing information, and to
“set permissions s-trace=rw” to display tracing information and configure
trace options. See “set permissions” for details on setting user permissions for
commands.
Syntax Display latest command options
The syntax and available options for “set trace” may vary by product and
product release. Enter the following command to view the current list of
options:
help set trace
Configure trace options
set trace [state={off|on|dump}]
[mode={historical|concurrent}]
[syslog={on|off}
[loghost=ip address]
[mask=type:severity]
Display tracing information
set trace