Installation guide

157

sendtime={0|1-65535} (milliseconds)

Indicates that data from the serial port should be sent out to the

network after the given amount of time has passed where no new data

has arrived from the serial port. This option only is valid when the

“buffered” option is “on.” A value of 0 (zero) disables this option.

The default is 0.

endpattern=string

Indicates that data from the serial port should be sent out to the

network after the given endpattern string has been found in the data

from the serial port. This option only is valid when the “buffered”

option is “on.” An empty string disables this option.

The maximum length of this string is 32 characters, including escape

sequences for special characters. For more details on the escape

sequences, see "Entering Special Characters in String Values”. The

maximum parsed length of this string is 4 characters. That is, this

string must reduce down to a 4-character string when the escape

sequences are processed.

strippattern={on|off}

This option corresponds with the “endpattern” option. When a valid

“endpattern” string is found, this option indicates whether the

matching string is stripped or kept in the data stream. The default is

“off.”

Examples #> set tcpserial hangupdcd=off idletime=20

#> set tcpserial port=1 sid=on sidstring=”abc”

#> set tcpserial port=1 buffered=on sendtime=50

sendcount=512

#> set tcpserial