Installation guide

130
Examples Disable service
#> set service range=1 state=off
Change the network port (ipport) of a service
#> set service range=1 ipport=500
Displaying the service table
In this example, the “set service” command displays the entire service table.
#> set service
Displaying an entry in the service table
In this example, the “set service” command displays a range of entries in the
service table.
#> set service range=2-4
Allow outgoing data that is unacknowledged or less than maximum
segment size.
#> set service ra=5 nodelay=on
See also • "revert"
• "set network"
• "set passthrough" for information on network services and applications that
are enabled and disabled by default when a ConnectPort LTS product is
configured for IP passthrough.
• "show"