Installation guide

113
Options port=range
Used to specify the serial port. Optional on a single-port device.
state={on|off}
Used to enable or disable the RTS toggle feature.
on
Enables the RTS toggle feature.
off
Disables the RTS toggle feature.
The default is “off”.
predelay=delay
Specifies the time in milliseconds to wait after the RTS signal is turned on
before sending data. The range is 0 to 5000 milliseconds. The default is 0.
postdelay=delay
Specifies the time in milliseconds to wait after sending data before turning
off the RTS signal. The range is 0 to 5000 milliseconds. The default is 0.
Example #> set rtstoggle state=on predelay=10
See also • "revert"
• "show"