Hardware manual

Q : How do I configure the settings to DiGi’s settings to enable me
to connect?
A : The built-in driver and client should already have DiGi’s settings. However,
in case you need to alter the settings, please follow the steps below:
Q : What does the blinking LED on the modem indicate?
A :
LED
Indicator
n
o
i
t
in
i
f
e
D
s
u
ta
tS
Blinking (on for 100ms and
off for 100ms; then on for
100ms and off for 2700ms)
Blinking (on for 100ms and
off for 2900ms)
Blinking (on for 100ms and
off for 2900ms)
The modem is powered on
The modem is registered to a GPRS
(GSM/GPRS/EDGE) network
The modem is registered to a
UMTS (WCDMA/HSDPA) network
The modem is removed
The modem is connected to
a GPRS network
On
The modem is connected to
a WCDMA network
On
The modem is connected to
a HSDPA network
On
Off
Green
Green
Blue
Green
Blue
Sky Blue
No Colour
Inserting the Micro SD card
Insert the Micro SD card into the E230, as shown in the following figure.
Note
:
• Micro SD card is an optional accessory. If the Micro SD card is not provided
in the package, you can buy one yourself.
• Do not remove the Micro SD card when it is being used. Removing the card
during operation may damage the Micro SD card as well as the device,
and data stored on the card may be corrupted.
Using the Clip
A clip is provided in the package of the E230. When you connect the E230 to a
laptop, you can fix the E230 to the clip, and hang the clip on the laptop.
4
N
o
t
e
: