Hardware manual

DG 158337 Broadband_UserGuide_E230_R1_22-15
FA size: 12cm(H) x 24cm(W)
Settings and Information Query
PIN Operations
If a SIM/USIM card is used on the terminal, the Personal Identity Number (PIN) code
protects your card from unauthorised use. You can modify the PIN code and
enable/disable the PIN verification.
Note:
The PIN code and PIN Unblocking Key (PUK) code are provided along with the
SIM/USIM card. For details, contact your service provider.
Enabling/Disabling the PIN Verification
You can enable the PIN Verification. If it is enabled, you need to verify the PIN code
when launching the Terminal Management again.
• To enable: Choose Tools
> PIN Operations >
Enable PIN Verification
• To disable: Choose
Tools > PIN Operations > Disable PIN Verification
Modifying the PIN Code
1. Choose Tools
>
PIN Operations
>
Modify PIN
2. In the
Modify PIN
dialog box, enter the current PIN code and the new PIN code
3. Enter the new PIN code again
4. Click OK to complete the modification
Note:
The PIN code should be a numeric string of 4~8 digits.
3
5
Failure to observe these instructions could result in your RF exposure exceeding the
relevant guideline limits.
Regulatory Information
The following approvals and notices apply in specific regions as noted.
CE Approval (European Union)
The wireless device is approved to be used in the member states of the EU. The
wireless device is in compliance with the essential requirements and other relevant
provisions of the Radio and Telecommunications Terminal Equipment Directive
1999/5/EC (R&TTE Directive).
Federal Communications Commission Notice (United States): Before a wireless
device model is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure.
The SAR limit adopted by the USA and Canada is 1.6 watts/kilogram (W/kg)
averaged over one gram of tissue. The highest SAR value reported to the FCC for
this device type was compliant with this limit.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
* This device should be installed and operated with a minimum distance of 20 cm
between the radiator and your body when using it via USB cable.
8078
1013 :re
bmuN
traP
10_
100
R001V :
noisreV
12