User`s guide

Configuration through the Default Web Interface
82  Digi Connect Family User’s Guide
Canceling Changes
To cancel changes you have made on a configuration change, click the Refresh or Reload
button on the Web browser. This will cause the browser to reload the page. Any changes
made since the last time you clicked the Apply button are reset.
Online Help
Online help is available for all screens of the default web interface, and for common
configuration and administration tasks. If you are new to device configuration, you might
also want to review the tutorial that is available on the Home page.
Change the IP Address, As Needed
Normally, IP address assignment is done through the Setup Wizard, and is the
recommended method. However, some organizations will not allow users to run wizards.
If you are unable to run the Setup Wizard, then you must assign an IP address to the
device using one of the alternative methods.
Changing an IP Address from a Web Browser
Prerequisite
This procedure assumes that the device server already has an IP address and you simply
want to change it.
Procedure
1
Open a web browser and enter the device server’s current IP address in the URL
address bar.
2 If security is enabled for the device, a login prompt is displayed. Enter the user
name and password for the device. If you do not know the user name and password,
contact the system administrator who initially set up the device.
3 Click Network to access the Network Configuration page.
4 On the IP Settings page, select “Use the following IP address.”
5 Enter an IP address (and other network-related parameters) and then click Apply to
save the configuration.