User`s guide

 77
Configuring the Digi Connect Devices
To Further Configure the Digi Connect Device
Once a Digi Connect device is configured through the Digi Device Setup Wizard, if any
configuration values need to be viewed or changed, you can use one of the other device
interfaces to view and change the configuration, such as the default web interface, Java
applet interface, or Command-Line Interface. See "Configuration through the Default
Web Interface" on page 77, "Configuration through the Java Applet Interface" on page 98,
and "Configuration Through the Command Line" on page 104 for more information.
Configuration through the Default Web Interface
This section describes using the default web interface to configure your Digi Connect
device. The interface is recommended for use if the Digi Device Setup Wizard is
unavailable, if your application requires specific alterations not accessible on the Wizard,
or if you wish to modify the device configuration from the values that were setup through
the Digi Device Setup Wizard.
Configuring Connect devices through the default web interface involves these tasks:
 Change the IP address, (must be configured. See page 82.
 Configure network communications. See page 83
 Configure mobile settings See "Configure Mobile Settings" on page 85.
 Configure the serial ports. See page 85.
 Configure GPIO pins (except Digi Connect SP, Digi Connect Wi-SP, and Digi
Connect WAN). See page 90.
 Configure alarms. See page 93.
 Configure security features. See page 96.
 Configure system settings. See page 97.
 Configure remote management. See "Configure Remote Management" on page
96
At any point in the configuration process, if you need to restore the device configuration
to factory defaults at any point in the configuration process, see "Restore Device
Configuration to Factory Defaults" on page 122.