User`s guide

68  Digi Connect Family User’s Guide
8 After you have configured the Digi Connect Wi-SP parameters to function within
your network, disconnect the power supply and the serial cable from your Digi
Connect Wi-SP
9 Reset your DIP switch settings according to your serial device requirements (EIA-
232/422/485).
10 Connect the antenna and the power supply to the Digi Connect Wi-SP.
11 Insert the Software & Documentation CD and follow the wizard to discover and the
configure your Digi Connect Wi-SP for your network.
Note You may also use the Digi support site http://www.digi.com/support/ for
additional command resources.
login: root
password: dbps
#>
DB-9
Pinouts
1
2
3
4
5
6
7
8
9
Shell
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
GND
CTS-
RxD+
TxD+
RTS-
GND
RxD-
RTS+
CTS+
TxD-
Not Used
RxD+
TxD+
Not Used
GND
RxD-
Not Used
Not Used
TxD-
**
*
Up/On
Down/Off
EIA-232
EIA-422/485
Full-Duplex
EIA-485
Half-Duplex
Switch
Settings
*If switch 4 is up, termination resistor connected
If down, termination resistor not connected.
*
*