User`s guide

 65
Configuring the Digi
Connect Devices
CHAPTER 2
This chapter describes how to configure Digi Connect devices. It covers the following
topics:
 Alternative configuration options for the Digi Connect Wi-SP
 Assign an IP address to the device, using one of the several alternative methods
– Configuration through the Digi Device Setup Wizard
– Configuration through the default web interface
– Configuration through the Java applet
– Configuration through the Command-Line Interface
– Customization through the Connectware Manager interface
The primary focus of this chapter is on configuring devices through the default web
interface. Configuration through the Java applet interface is mentioned, but not at the
same level as the default web interface. Connectware Manager interface cannot set the IP.
To use Connectware Manager you must set up the Digi device with the Digi Device Setup
Wizard and then install Connectware Manager. For more information, see the
Connectware Manager User’s Guide.
Alternative Configuration Options for Digi Connect Wi-SP
If you prefer to configure the Digi Connect Wi-SP with a serial connection, you have
several alternative options.