User`s guide

 59
Introduction
 Updating firmware
 Restoring the configuration to factory defaults
 Rebooting the module
Chapter 4, "Administering Digi Connect Devices" covers device administration in more
detail.
RF Exposure Statement
Digi Connect Wi-SP, Digi Connect Wi-EM, and Digi Connect Wi-ME
The Digi Connect Wi-EM and Wi-ME embedded modules comply with the RF exposure
limits for humans as called out in RSS-102.
These devices are exempt from RF evaluation based on its operating frequency of 2400
MHz, and effective radiated power of 100 milliwatts. This would be less than the 3 watt
requirement for a mobile device (>20 cm separation) operating at 2400 MHz.
Digi Connect WAN and Digi Connect RG
In order to comply with RF exposure limits established in the ANSI C95.1 standards, the
distance between the antenna(s) and the user should not be less than 20 cm.
FCC Certifications for Digi Connect ES and Digi Connect RG
For FCC certification for other Digi Connect devices, see the Hardware Reference.
FCC Part 15 Class A
These devices comply with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) These devices may not cause harmful interference, and (2) These
devices must accept any interference received, including interference that may cause
harmful operation.