User`s guide

 29
Introduction
 Ethernet duplex mode: full-duplex, half-duplex, with auto-sensing of duplex
mode for Digi Connect SP, Digi Connect ME, Digi Connect EM, Digi Connect
WAN, and Digi Connect RG.
 Ethernet connector: RJ-45 for Digi Connect SP, Digi Connect ME, Digi
Connect WAN, and Digi Connect RG.
 RJ-45 or pin header for Digi Connect EM.
 Serial connector: DB-9M for Digi Connect SP, Digi Connect Wi-SP,Digi
Connect WAN, and Digi Connect RG. TTL-level pins for Digi Connect ME,
Wi-ME, Digi Connect EM, and Wi-EM.
Wireless Devices Digi Connect Wi-ME, Wi-EM, Wi-SP, and Digi Connect WAN (see
also "Wireless Networking Features" on page 30):
– Wireless Modulation: CCK (11/5 Mbps), DQPSK (2 Mbps), DBPSK (1 Mbps)
– Wireless Transmit Power: 16 dBm
– Wireless Receive Sensitivity: -82 dBm at 11 Mbps
– Wireless Antenna Connector: 1 x RP-SMA for Digi Connect Wi-ME, Wi-SP,
and Digi Connect WAN; 2 x RP-SMA for Digi Connect Wi-EM
– Wireless Security: Wi-Fi Protected Access (WPA/WPA2/802.11i), Wired
Equivalent Privacy (WEP)
 Full-duplex
Half-duplex
 Auto-sensing of duplex mode
Configurable Network Services
Access to network services can be enabled and disabled. This means that you can restrict a
device’s use of services to only those strictly needed by the device. To improve device
security, you can also turn off any non-secure services, such as Telnet. Network services
that can be enabled or disabled include:
 Advanced Digi Discovery Protocol (ADDP)
 RealPort (not supported in Digi Connect WAN)
 Encrypted RealPort (not supported in Digi Connect WAN)
 HTTP/HTTPS
 Line Printer Daemon (LPD) (not supported in Digi Connect WAN)
 Remote Login (rlogin) (not supported in Digi Connect WAN)